Konica Minolta magicolor 4750EN-4750DN - Manual (Page 112)

Configuration Menu Overview 4-69
THICK
MODE
Settings
QUALITY MODE / SPEED MODE
In order to prevent toner from clogging within the
developer unit as a result of it being driven at
half-speed, select the timing for driving the devel-
oper unit at full speed for a fixed length of time when
thick paper is being fed.
QUALITY MODE
: While printing on thick paper, print-
ing is periodically paused, and the developer unit is
driven at full speed for a fixed length of time. Since
printing is paused, the quality is not affected; how-
ever, a standby time of approximately 70 seconds
occurs every 400 seconds or so of half-speed oper-
ation.
SPEED MODE
: While printing on thick paper, only the
drive of the developer unit periodically switches to
full speed for a fixed length of time. Since printing
continues during full-speed drive, the print quality is
slightly affected, however the standby time is short.
ENGINE
DIPSW
ENGINE
DIPSW
1-28
Settings
ON / OFF
Use to change engine settings.
"
Normally, there is no need to change the
settings. If it becomes necessary to change
the settings, do so according to the
instructions from Technical Support.
MAIN
SCAN
ADJUST
MAIN
SCAN
PAGE
Settings
PRINT / CANCEL
Print the test pattern for fine adjustment of the color
ratios in the main scanning direction.
SCAN
ADJUST
VALUE
YELLOW
Settings
42 - 0 - -42
Finely adjust the ratio of yellow in the
main scanning direction.
MAGENTA
Settings
42 - 0 - -42
Finely adjust the ratio of magenta in the
main scanning direction.
CYAN
Settings
42 - 0 - -42
Finely adjust the ratio of cyan in the main
scanning direction.