Konica Minolta magicolor 4750EN-4750DN - Manual (Page 188)

Replacing Consumables 7-35
8
Reconnect the power cord, and
turn on the printer.
9
Use DATE on the SYS DEFAULT MENU/CLOCK menu to set the date,
and use TIME on the SYS DEFAULT MENU/CLOCK menu to set the
time.
Replacing the Fuser Unit FU-P02
When the time to replace the fuser unit is reached, the message FUSER
UNIT/END OF LIFE appears. Printing can continue even after this mes-
sage appears; however, since the print quality is reduced, the fuser unit
should be replaced immediately
1
Turn off the printer.
Note
There are extremely hot parts within the machine. Before replacing the
fuser unit, wait about 20 minutes after turning off the machine, and then
check that the fusing section has reached room temperature, otherwise,
you may get burnt.