Konica Minolta bizhub PRO 2000P - Manual (Page 111)

111
Install New Stitch Wire
Feed the Stitch-wire
[67]
4 Close the folder cover.
5 Close the connecting bridge
cover.
Step Action Information
Step Action Information
1 Touch START.
3 Set the number of stitches to 6 Touch BASIC > STITCHES.
4 Hand-feed or print an A4 or
larger size test job. The stitch-wire loads automatically
during the stitch head cycle.
5 Check that the stitch-wire is
loaded. Check that a stitch is made. If needed,
repeat the previous step.
If a stitch is still not made, repeat the
procedure. Install the stitch-wire into
the stitch head
Install the Stitch Wire
into the Stitch Head on page 110 .
6 Reset the number of stitches
on the touch screen.