Konica Minolta bizhub PRO 2000P - Manual (Page 60)

60 Chapter 5 Error Conditions, Problems, and Solutions
Error Messages
SHUTTLE MOTOR
ERROR Use the ON/OFF switch.
Turn the machine OFF,
then turn the machine
ON. If the problem
continues, call your
service engineer.
SHUTTLE NOT
PARKED The shuttle is in the
wrong position. Touch
START to reset the
position.
Then touch STOP to clear
the message from the
screen.
Sidelay axis moving The sidelay axis (size
adjustment) is adjusting.
This message clears when
the adjustment is
complete.
If the message does not
clear, touchADVANCED
> RE REF.
STACKER FULL The stacker is full.
Unload the books from
the stacker.
Stitch axis moving The stitch axis is moving.
This message clears when
the adjustment is
complete.
If the message does not
clear, touchADVANCED
> RE REF.
Stitch position adjusting The stitch position is
adjusting. This message
clears when the
adjustment is complete.
If the message does not
clear, touchADVANCED
> RE REF.
Problem Cause Solution