Konica Minolta MAGICOLOR 2300 - Manual (Page 124)

Status, Error, and Service Messages 114
Service Messages
A service message sometimes occurs as a result of an unusual combination
of events, not because of an actual problem. When the printer stops and a
service message displays in the message window, turn the printer off and
then back on. This often clears the service message indicator, and printer
operation resumes. Always try this before making a service call.
Service calls should be placed to the vendor from whom you purchased
the printer. If you cannot get service from your vendor, see the Service &
Support Guide for a list of sources of service and support in the Americas.
The most up-to-date worldwide information can be found at
www.konicaminolta.net/printer/.
This service
message... means... do this...
ERROR
AIDC SENSOR AIDC sensor error. Contact Technical
Support with the error
information.
ERROR
COMMUNICATION A communication error
occurred in the parallel,
USB or Ethernet
interface. Check that the interface
cable is properly
connected to the printer.
If the error continues to
appear even though the
cables are correctly
connected, contact
Technical Support.
ERROR
CONTROLLER Controller internal error. Contact Technical
Support with the error
information.
ERROR
DIMM SDRAM DIMM error. Contact Technical
Support with the error
information.
ERROR
RAM RAM writing/reading
error. Contact Technical
Support with the error
information.
ERROR
ROM ROM error.