Konica Minolta MAGICOLOR 2300 - Manual (Page 153)

Reinstalling the Printer 143
2
Place the OPC drum and transfer
belt unit (in their protective bags) in
the appropriate position in the box
supplied in the repacking kit.
"#
Also pack the supplied roll of
tape in this box.
If you return the printer for service in
the Americas, be sure to also write
the RMA (Return Merchandise
Authorization) number you received
from your customer support
representative on the outside of the
box before shipping the
consumables.
3
Securely tape the top flaps of the
box closed.
Reinstalling the Printer
If you are shipping the printer to another
location, follow steps A–I below to
reinstall the printer once received.
A. Unpack the printer carton. Refer to the magicolor 2300 DL
Installation and User’s Guides.
B. Rotate the transfer belt release
lever and reinstall the transfer belt unit. See “Reinstalling a Transfer Belt
Unit” on page 144.
C. Install the OPC and return the
transfer belt release lever to its correct
position (7 o’clock).* Refer to the magicolor 2300 DL
Installation and User’s Guides.
*The printer must complete a
150-second calibration cycle after
a consumable has been replaced.
If you open the door before the
message window reads
IDLE/
MAGICOLOR 2300DL , the printer
stops and repeats the calibration
cycle
D. Install a new waste toner bottle.
E. Replace the toner cartridges.*
F. Install the tray 1 media support and
load the media.
G. Reconnect the power cord and
cables.
H. Install the options.
I. Turn the printer on.