Konica Minolta MAGICOLOR 2300 - Manual (Page 136)

Duplex Option 126
6
Attach the support wire for the duplex option to the printer.
a Pull the right-side door release
lever, and open the right-side
door.
If you have lower feeder unit
attached, you first need to open
the lower right-side door.
b Pull the tab for the support wire
on the right side of the duplex
option, and then hook the wire
onto the hook of the printer.
c Close the right-side door(s).
7
Reconnect interface cable.
8
Reconnect the power cord, and turn
on the printer.
"#
In compliance with UL
guidelines, “The appliance inlet
is considered to be the main
disconnect device.”
9
Check the configuration page from the
control panel (Special Pages/Print
Config Page menu) to verify the duplex option installation.
10
Configure your driver for the new duplex option (see Chapter 4).
% % % %
$ $ $ $