Konica Minolta magicolor plus - Manual (Page 30)

E-30
① Save the header/footer file in the USB memory.
Do not save within a folder of the USB memory. When USB
memory is inserted in the USB port of the Captureboard, the
Captureboard will search for the .hfd file. If the file has been
saved within a folder, reading of the file will not be possible.
Note also that you should save only the target file. Reading will
not be possible when multiple header/footer files exist.
② Insert the saved USB memory into the USB port of the
Captureboard.
When the header/footer file has been found, [HF] will flash in
the display window of the Captureboard.
③ Press the [Save] button of the Captureboard control panel.
When the updating of the header/footer information is com-
pleted, the Captureboard display window will change to display
[H1].
Press a button other than "Save" or "Feed" on the main unit's
control panel.
[H1] of the Captureboard display window will change to the
[OP] display and the normal mode will be set.
To return to the header/footer default setting (i.e., only the date
and time display), press the “Feed/Stop” button.
The display will change to the [H0] display of the Captureboard
display window.
Updating from USB Memory
USB Memory
Creation and Editing of Headers/Footers
• When printing header/footer information or adding it to a transfer image, go to [Setup] and set [Header/Footer] of
[Hardware Setup] to “Enable”. (See Page E-22)
Caution