Konica Minolta KIP 3100 - Manual (Page 25)

Chapter 2 Basic Operation 2-5
2. 3 Roll Media Replacement
1. Open Roll Deck (1) and remove the empty roll core.
2. Move the right Slide Guide (2) to match your roll media’s width.
The right and left Side Guides will automatically move together.
NOTE
A paper mis-feed may occur just before an end of roll paper condition.
Reference
This section describes how to install a roll of media to Roll Deck 1.
The same procedure is applied to Roll Deck 2, unless otherwise noted.
2 2: Roll 1
2: Roll 2 Hold here to slide
1
Roll Core
NOTE
Please confirm that the machine has finished the printing completely before opening the Roll
Deck. If you open the deck while it’s still printing, a paper mis-feed may occur.