Konica Minolta magicolor 3730DN - Manual (Page 140)

Solving Other Problems 7-25
Printing
takes too
much time. The printer is set to a
slow printing mode
(for example thick
stock). It takes more time to print on special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
The printer is set to
Energy Saver mode. It takes time for printing to start in
Energy Saver mode. If you do not want
to use this mode, contact Technical
Support.
The job is very com-
plex. Wait. No action needed.
A toner cartridge for a
different region or an
unapproved genuine
toner cartridge is
installed (
INCOR-
RECT X T/C
is displayed in the
message window).
Install a correct KONICA MINOLTA
toner cartridge approved for your spe-
cific printer.
Blank pages
come out
during print-
ing. One or more of the
toner cartridges are
defective or empty. Check the toner cartridges. The image
will not print if one or more cartridges
are empty.
The wrong media is
being used. Check that the media type set in the
driver matches the media loaded in the
printer.
The machine
does not
enter Energy
Saver mode. Paper has been
loaded into Tray 1. Remove all paper from Tray 1.
Paper
cannot be
loaded into
Tray 1. The machine has
entered Energy
Saver mode. After the machine is ready for opera-
tion, load paper into Tray 1.
Symptom Cause Solution