Konica Minolta bizhub 500 - Manual (Page 84)

3
Using scan functions
3-6 bizhub 500/420
Usin
g sca
n fu
nc
tion
s
Ch
ap
te
r 3
To use a program
“Program” refers to the set of destinations and scan
settings that are registered together. These are
convenient for frequently sending transmissions with
the same settings.
If a destination has not been registered with a program,
the destination cannot be specified.
The following procedure describes how to send data
by selecting a program that has been registered in
advance.
%
In the Program Screen, touch the key for the
desired program.
– Touch [Index List] to select the page of program
destinations to be displayed.
– To cancel the setting, touch the key again to
deselect it.
– To clear all of the selected destinations, press
[Reset].
– To check/delete the specified destination, press
[Mode Check]. For details on checking/deleting
destinations, refer to “Checking the settings
(Mode Check)” on page 5-10.