Konica Minolta BIZHUB C652DS - Manual (Page 141)

bizhub C652/C652DS/C552/C552DS/C452 2-123
2.41 Reporting the status of this machine (TRAP) 2
2.41.3 TRAP Settings
In the administrator mode of PageScope Web Connection, select "Network" ö "SNMP Setting".
2.41.4 Status Notification Setting
In the administrator mode of PageScope Web Connection, select "Maintenance" ö "Status Notification
Setting" ö "IP (IPX) Address" ö [Edit].
Item Description Prior check
IPX Setting Select "ON".
Ethernet Frame
Type Select a frame type to be used. Frame type
Item Description Prior check
Allow Setting Select "Allow".
Trap Setting when
Authentication
Fails Select whether to enable TRAP transmission at the time of
authentication failure.
Item Description Prior check
Notification ad-
dress If the destination has an "IP address", enter it. If the DNS
server has already been configured, you can enter the
host name instead."If IPv6" is set to "ON", you can also
specify the IPv6 address.
If the destination has an "IPX address", enter it using an 8-
digit hexadecimal value. Notification address
Port Number If the destination has an "IP address", enter its port
number.
Node Address If the destination has an "IPX address", enter the node ad-
dress using a 12-digit hexadecimal value.
Community Name Enter a community name (up to 15 characters).
Replenish Paper
Tray Sends a notification when the paper tray is empty.
JAM Sends a notification when a page has been jammed.
PM Call Sends a notification when the periodical inspection is re-
quired.
Replace Staples Sends a notification when there are no staples remaining.
Replenish Toner Sends a notification when the toner is empty.
Finisher Tray Full Sends a notification when the capacity of the finisher tray
has been exceeded.
Service Call Sends a notification when a service call has occurred.
Job Finished Sends a notification when the job has finished.
Hole-Punch Scrap
Box Full Sends a notification when you need to empty the punch
scrap box.
Waste Toner Box
Full Sends a notification when the waste toner box needs to be
replaced.
Imaging Unit Yield Sends a notification when the imaging unit (IU) needs to
be replaced.
Fusing Unit Yield Sends a notification when the fusing unit needs to be re-
placed.
Transfer Roller Unit
Yield Sends a notification when the transfer roller unit needs to
be replaced.
Transfer Belt Unit
Yield Sends a notification when the transfer belt needs to be re-
placed.