Konica Minolta bizhub 20 - Manual (Page 31)

Chapter 3
22
Tray Use in print mode
3
You can change the default tray the machine
will use for printing from your computer.
a
Press Menu, 1, 6, 3.
b
Press a or b to choose Tray#1 Only,
Tray#2 Only
1
, MP Only,
MP>T1>T2
1
or T1>T2
1
>MP.
Press OK.
1
Tray#2 Only or T2 appears only if the
optional tray is installed.
c
Press Stop/Exit.
Note
• The setting in the printer driver will take
priority over the setting made on the
control panel.
• If the control panel is set to
Tray#1 Only, MP Only or
Tray#2 Only
1
and you choose
Auto Select in the printer driver, the
machine pulls the paper from that tray.
1
Tray#2 Only appears only if the optional tray is
installed.
Volume settings
3
Ring volume
3
You can choose a ring volume level from a
range of settings, from High to Off.
While in Fax mode press or to adjust
the volume level. The LCD will show the
current setting, and each key press will
change the volume to the next level. The
machine will keep the new setting until you
change it.
You can also change the ring volume through
the menu:
a
Press Menu, 1, 3, 1.
b
Press a or b to choose Off, Low, Med or
High.
Press OK.
c
Press Stop/Exit.
Beeper volume
3
When the beeper is on, the machine will beep
when you press a key, make a mistake, or
after you send or receive a fax. You can
choose a range of volume levels, from High
to Off.
a
Press Menu, 1, 3, 2.
b
Press a or b to choose Off, Low, Med or
High.
Press OK.
c
Press Stop/Exit.