Konica Minolta FK-102 - Manual (Page 68)

Reserving Transmission - (continued)
2-30
Bundled Transmission
When you are transmitting a newly reserved document to a destination that is the same as the
destination for which an already-reserved document is intended, you can send both at the
same time as a bundled transmission. A maximum of five documents can be sent continu-
ously.
In order for the continuous transmission function to be activated, it is necessary that the fol-
lowing transmission conditions for documents being transmitted and transmission reserved
documents are the same.
•
Memory Tx, Resolution, Int’l com, ECM, V34.
•
Confiden.Tx, Relay Tx req, Compulsory mem.Rx, Polling Tx or Forwarding Tx must not be
designated.
•
Continuous transmission is available when the continuous transmission function of Key
Operator mode is set to ON. Refer to "Turning ON/OFF transmission/reception functions"
(p. 10-32) for information on setting. The continuous transmission function is set to ON at
the time of purchase.
•
The continuous transmission function cannot be used for documents for which communi-
cation is already in progress.
Reminder!
FOR DETAILS
The following types of jobs
can be sent at the same time.
The documents are transmitted at the same time
• Memory Tx
• Resolution
• Int'l com
• ECM
• V34
• Confiden.Tx/Relay Tx req/Compulsory
mem.Rx/Polling Tx/Forwarding Tx must
not be designated
Destination
1234-5678
Destination
1111-2222
Destination
1234-5678
transmis-
sion reser-
vation
document
➀
transmis-
sion reser-
vation
document
➁
transmis-
sion reser-
vation
document
➂
FAX Memory