Konica Minolta Magicolor 5440 DL - Manual (Page 149)

Dual In-Line Memory Module (DIMM) 139
5
Insert the new DIMM straight
into the DIMM connector until
the latches snap into the locked
position.
Observe the keyed side of the
DIMM to align it with the connec-
tor. If you cannot snap the DIMM
into place, do not force it. Repo-
sition it, making sure that the
DIMM is seated completely in
the connector.
6
Reinstall the panel and tighten the seven screws.
7
Attach the rear cover.
8
Reconnect all interface cables.
9
Reconnect the power cord, and
turn on the printer.
10
Print a configuration page ( SPECIAL PAGES/PRINT CONFIG PAGE
MENU ) and verify that the total amount of the RAM installed in your printer
is listed.