AEG BE3003021M - Manual (Page 31)

Replacing the lamp:
1.
You can find the lamp glass cover at the left side of the cavity.
Remove the left shelf rail.
2. Use a narrow, blunt object (for example
a teaspoon) to remove the glass cover.
Clean the glass cover.
3. If necessary, replace the lamp with ap-
plicable 300°C heat-resistant lamp.
Use the same lamp type.
4. Install the glass cover.
5. Install the left shelf rail.
Door and glass panels
To clean the door, remove it.
CAUTION!
Be careful when you remove the door from the appliance. The door is heavy!
Removing the door
1.
Open the door as far as it goes.
2. Fully press clamping levers (A) on the
two door hinges.
3. Close the door until the first position
(angle approximately 70°).
4. Hold of the door with one hand on each
side and pull it away from the at an up
angle.
To install the door follow the procedure in
reverse.
The number of glass panels if different for the different models.
CAUTION!
Put the door with the outer side down on a soft and level surface to prevent scratches.
Removing and cleaning the door glass panels
1.
Remove the door.
A
A
Care and cleaning 31