AEG BE3003021M - Manual (Page 33)

Problem Possible cause Solution
The pyrolytic cleaning does not
operate (the time display shows
„C3“)
The door is not correctly closed
or door lock is defective
Close the door correctly
The display shows C2 You want to start the pyrolytic
cleaning or defrost function
but you did not remove core
temperature sensor plug from
the socket.
Remove the core temperature
sensor plug from the socket
The display shows F102 • The door is not closed cor-
rectly
• The door lock is defect
• Close the door correctly
• Switch off the appliance
with the house fuse or the
safety switch in the fuse box
and switch it on again
• If the display shows F102
again, refer to the Customer
Care Department
The display shows an error code
that is not in this list
There is an electronic fault • Switch off the appliance
with the house fuse or the
safety switch in the fuse box
and switch it on again
• If the display shows the er-
ror code again, refer to the
Customer Care Department
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the
front frame of the appliance cavity.
We recommend that you write the data here:
Model (MOD.)
.........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
INSTALLATION
WARNING!
Refer to "Safety information" chapter.
The built-in unit must meet the stability requirements of DIN 68930.
Installation 33