Burnham V8 Series User Manual
Page 26
26
SECTION III: PACKAGED BOILER ASSEMBLY
A. REMOVE CRATE.
1. Remove all fasteners at crate skid.
2. Lift outside container and remove all other inside
protective spacers and bracing. Remove draft
regulator box and miscellaneous trim bag containing
safety or relief valve, and pipe fi ttings.
B. REMOVE BOILER FROM SKID.
1. Boiler is secured to base with 4 bolts, 2 in front and
2 in rear of shipping skid, see Figure 11. Remove all
bolts.
N
O
I
T
U
A
C
r
e
l
i
o
b
p
m
u
b
t
o
n
o
D
.
r
e
l
i
o
b
p
o
r
d
t
o
n
o
D
.
r
o
o
l
f
t
s
n
i
a
g
a
t
e
k
c
a
j
C. MOVE BOILER TO PERMANENT POSITION
by sliding or walking.
D. PROCEDURE TO OPEN, CLOSE AND SECURE
BURNER SWING DOOR with articulated hinge.
Throughout this manual you will be instructed to
open and close the burner swing door for various
reasons. There is a proper and improper method to
closing and securing the burner swing door after it
has been removed and re-installed for Field Assembly
(Knockdown Boiler) or opened for inspection, cleaning
or fi eld service.
1. TO OPEN BURNER SWING DOOR (see Figures
11A and 11B).
Step 1. Loosen and remove right side latching
hardware (5/16" fl ange nut and washer).
Step 2. Loosen and remove left side hinge hardware
(5/16" x 3-1/2" lg. hex head fl ange bolt).
Step 3. The duel pivot articulated hinge allows right
side of door to be pulled outward and rotated
to the left all in one motion. To do so, place
your right hand under burner air tube and lift up
slightly to help carry the weight of the door and
burner. Use your left hand to grasp the door's
left side hinge fl ange, pull outward to rotate the
hinge, this motion will move the door outward
and to the left approximately 3" (see Figure 11B,
Position 2).
Figure 11: Packaged Boiler Removal from Skid
Figure 11A: Partial Front View - Burner Swing Door Mounted to Boiler - Fully Closed and Secured
2. Tilt boiler to right and to rear. Using right rear leg
as pivot, rotate boiler 90° in a clockwise direction,
and lower left side of boiler to fl oor. Tilt boiler and
remove crate skid. Care should be exercised to
prevent damage to jacket or burner.