Olympus PT-024 - Manual (Page 17)

E-16
Load the digital camera.
Quietly load the digital camera into the Case, taking care that the
projecting part of the zoom lever of the digital camera properly fits
into the recessed part of the zoom lever of the Case.
Setting the Zoom Lever
When loading the digital camera in the Case, fit the projecting part
of the zoom lever of the digital camera into the recessed part of the
zoom lever on the inside of the Case.
: • When loading the camera, confirm that the projecting
part of the zoom lever of the camera is properly set to
the recessed part of the zoom lever of the Case.
• When the setting is insufficient, the loading of the
camera becomes imperfect and it may not be possible
to seal the Case or zooming may not function.
Insufficient sealing will cause water leakage.
CAUTION
Set the mode dial.
After the digital camera has been
loaded, push down the mode dial
of the case from the upper surface
of the case and set it so that the
lower part of the mode dial of the
case on the inside of the case fits
properly onto the upper part of the
mode dial of the digital camera.
Advice • After properly fitting the case's mode dial knob, turn the
knob to make sure that the camera's mode dial switches
before closing the case tightly.
PT024_E.qxd 2004.4.20 10:33 AM ページE-16