Olympus PT-024 - Manual (Page 21)

E-20
Perform the final checks.
Visual Inspection
After sealing the Case, check the sealing part of front and rear lid
visually to confirm that the O-ring is not twisted or out of the groove
and that no foreign matter has been caught.
Fit the lens cap onto the lens
ring as shown in the figure. Be
sure to remove the lens cap
before shooting.
Mounting and Removing the Lens Cap
: • After loading the camera into the Case, confirm that the
mode dial moves. If it does not move, there is the
possibility that oil or fat has been attached to the mode
dial. Please wipe it clean.
CAUTION
Try to move the mode dial.
After sealing, turn the mode dial knob and confirm that the mode
dial of the camera is switched.
: • Hairs, fibers, and other narrow items are not very apparent,
but they may cause entry of water, so that special attention
is required.
CAUTION
PT024_E.qxd 2004.4.20 10:33 AM ページE-20