Olympus EVOLT E-510 - Manual (Page 45)

EN
45
Sho
oting fun
ctions
k
Various shooting functions
3
Non-specified commercial flashes
1) Exposures when using a flash require that adjustments be made on the flash. If a flash is
used in the auto mode, match it with the f-number and ISO sensitivity settings on the
camera.
2) Even if the flash auto f-number and ISO sensitivity are set the same as on the camera, the
correct exposure may not be obtained depending on the shooting conditions. In such a
case, adjust the auto f-number or ISO on the flash or calculate the distance in the manual
mode.
3) Use a flash with an illumination angle that matches the focal length of the lens. The focal
length of the lens for 35 mm film is approximately twice as long as the focal length of the
lenses designed for this camera.
4) Do not use a flash unit or other accessory TTL flash that has additional communication
functions other than the specified flashes, since it may not only fail to function normally,
but may also cause damage to the camera’s circuitry.
Setting the functions
j/ Y/<Control dial
• When settings are made with the j/ Y/< button, the
information is also displayed on the viewfinder.
i p: j/</Yi
Sequential shooting
Single-frame shooting o Shoots 1 frame at a time when the shutter button is pressed
(normal shooting mode).
Sequential shooting j Shoots 12 frames or more at 3 frames/sec. for as long as the
shutter button is pressed (during JPEG). Focus, exposure, and
white balance are locked at the first frame (during S-AF, MF).
• Press the shutter button fully and keep it pressed. The camera will take pictures in sequence until
you release the button.
Sequential shooting/Self-timer/Remote control
Direct button
Control panel screen
j/ Y/< button Control dial
i button
:
Single-frame shooting
:
Sequential shooting
Sequential
shooting
Self-timer
:
12-second self-timer
:
2-second self-timer
Remote control
:
0 second
:
2 seconds
s0010_e_00_unified.book Page 45 Tuesday, April 10, 2007 5:23 PM