The image quality is poor – Olympus C-5050 Zoom User Manual
Page 211
210
Troubleshooting
11
Misc
ella
ne
ous
The image quality is poor.
Erasing, protecting or rotating pictures, setting print reservation data, and formatting
cards cannot be performed.
Possible cause
Corrective action
Ref. Page
A write-protect seal is
attached to the SmartMedia
card.
Remove the seal before using the
SmartMedia card. Do not reuse the write-
protect seal.
The settings are returned to the factory default settings when the camera is turned off.
Possible cause
Corrective action
Ref. Page
All Reset is set to ON.
Select the SETUP tab in the mode menu
and set All Reset to OFF.
No picture is displayed on the TV when connected to the camera.
Possible cause
Corrective action
Ref. Page
The video output signal is
incorrect.
Set the video output signal according to the
region where used.
The camera is not in the
playback mode.
Set the mode dial to
.
The TV video signal setting is
incorrect.
Set the TV to the video input mode.
The picture is too bright.
Possible cause
Corrective action
Ref. Page
The flash was set to the fill-in
flash mode.
Select a flash mode other than fill-in flash.
The subject was excessively
illuminated.
Adjust the exposure compensation toward
minus (-) or change the camera position.