Olympus D-150-C-1 - Manual (Page 21)

21
PREPARATION
ⅷ CR-V3 lithium battery packs cannot be charged.
ⅷ Alkaline batteries have a lot of variation in their performance and deteriorate
particularly at low temperatures. It is recommended that lithium battery packs
or NiMH batteries be used.
ⅷ Zinc-carbon (manganese) batteries and R6/AA lithium batteries cannot be used.
Please read the separately provided “Battery Handling Precautions”.
ⅷ If the terminals inside the battery compartment are dirty, it will noticeably
shorten the life of the batteries. Do not touch the inside of the battery
compartment.
ⅷ If the camera is left for about 1 hour with the batteries or battery pack removed,
the date/time setting will revert to the default setting.
ⅷ Be sure to turn the camera off before replacing the batteries or battery pack.
Removing the batteries or battery pack (or unplugging the AC adapter) while the
camera’s power is on may reset the date/time settings.
ⅷ An alarm could sound if exhausted batteries are left in the camera for long.
Replace the batteries with new ones in this case.
Do not use batteries whose exterior is not completely covered by an insulating
sheet. If such batteries are used, they may cause leakage, excessive heat, or
explosion. Some batteries are sold with a partial insulating sheet, or without
any insulating sheet at all. Do not use these batteries under any circumstances.
The following R6/AA batteries cannot be used
ⅷBatteries whose exterior is only partially
covered, or not covered at all, by an
insulating sheet.
ⅷBatteries whose œ terminals are raised, but
not covered by an insulating sheet.
ⅷBatteries whose œ terminals are flat and not
completely covered by an insulating sheet.
(Such batteries cannot be used even if the œ
terminals are partially covered.)