Olympus C-730 Ultra Zoom - Manual (Page 99)

98
Chapter 5
Remote control (Cont.)
● If the camera’s self-timer/remote control lamp does not blink after
pressing the shutter button on the remote control.
T The remote control may be too far away from the camera. Move within
the remote control’s effective range and press the shutter button on the
remote control again.
T There may be signal interference. Change the signal as described in
the remote control’s instructions.
● How to cancel the remote control mode.
T The remote control mode is not canceled automatically after shooting.
Perform step 2 on page 97: Set / to OFF.
● You can utilize the camera as a presentation tool with a TV by using
the remote control to operate the following playback features.
T The slide-show, close-up, and index playback features are available.
TIPS
● If the remote control receiver is exposed to strong light, such as direct
sunlight, the effective signal distance may be reduced or shooting may not
take place.
● To shoot sequential shots using the remote control, press and hold the
shutter button on the remote control. If the camera does not receive the
remote control signal properly, sequential shooting may stop.
● Read the remote control’s instructions for information on playback with the
remote control.
Note