Olympus Stylus 1050 SW - Manual (Page 47)

47 EN
Make the settings for the functions while referring to “Using the Menu” (p. 3).
To play back camera images on a TV
1 Connect the TV and camera.
Connect to the TV video
input jack (yellow) and
audio input jack (white).
Multi-connector
AV cable (supplied)
Connector cover
2 Use the camera to select the same video signal system as the one of connected TV ([NTSC]/
[PAL]).
3 Turn on the TV, and change “INPUT” to “VIDEO (an input jack connected to the camera).”
For details on changing the input source of the TV, refer to the TV’s instruction manual.
4 Set the mode dial to q, and use 1234 to select the image for playback.
Depending on the TV’s settings, the displayed images and information may become cropped.
Saving battery power between shots
[POWER SAVE]
x SETUP X POWER SAVE
Submenu 2 Application
OFF Cancels [POWER SAVE]
ON
When the camera is not being
used for approx. 10 seconds, the
monitor automatically turns off to
save battery power.
To resume standby mode
Press any button or turn the mode dial.
Using the LED illuminator as an
auxiliary light [LED ILLUMINATOR]
x SETUP X LED ILLUMINATOR
Submenu 2 Application
OFF Disables the LED illuminator.
ON Enables the LED illuminator.
“Using the LED illuminator” (p. 23)
book_oima_myu1050SW_en.indb 47 book_oima_myu1050SW_en.indb 47 2008/07/10 11:49:46 2008/07/10 11:49:46