Olympus E-3 - Manual (Page 33)

33
EN
1
Basic camera operations
Normally, current camera settings (including any changes you have made) are retained when
the power is turned off. To reset the camera to the factory default settings, set [RESET]. You
can register settings in advance to [RESET1] and [RESET2]. The camera settings at that
time are registered in [RESET1] and [RESET2]. For details on the registered functions, refer
to “Functions that can be registered with My Mode and Custom Reset Setting” (
gP. 134).
Registering [RESET1]/[RESET2]
1
Select either [RESET1]/[RESET2] to register and press d.
• If settings have already been registered, [SET] is displayed next to [RESET1]/[RESET2].
Selecting [SET] again overwrites the registered setting.
• To cancel the registration, select [RESET].
2
Select [SET] and press the i button.
Using reset settings
You can reset the camera to [RESET1] or [RESET2] setting or restore the factory default
settings.
[RESET]
: Resets to the factory default settings. For the default settings, see
“Menu directory” ( gP. 135).
[RESET1]/[RESET2] : Resets to the registered settings.
• Holding down the F button and ISO button at the same time for 2 seconds performs
[RESET].
• While pressing two buttons at the same time, turn the dial to select the reset setting.
Release the button to reset the settings.
1
Select [RESET], [RESET1] , or [RESET2] and press
the
i button.
2
Use ac to select [YES], then press the i
button.
Resetting to the factory default settings
Menu MENU[W][CUSTOM RESET]
Direct button F + ISO
Viewfinder : RESET
: RESET1
: RESET2
Control panel
Menu MENU[W][CUSTOM RESET]
RESET1
YES
NO
CANCEL SELECT GO
s0011_e_00_0_unified.book Page 33 Wednesday, September 12, 2007 4:46 PM