Standby mode, Standby mode -10 – Toshiba SATELLITE M30X User Manual

Page 58

Advertising
background image

User’s Manual

3-10

Getting Started

Data saved in Hibernation Mode

When you turn off power in Hibernation Mode, the computer takes a

moment to save current memory data to the hard disk. During this time, the

Built-in HDD indicator will light.
After you turn off the computer and memory is saved to the hard disk, turn

off the power to any peripheral devices.

Standby Mode

In Standby Mode the power remains on, but the CPU and all other devices

are in effectively in a state of 'sleep'.

Standby Mode precautions

Before entering Standby Mode, be sure to save your data.

Do not remove/install memory or remove power components:

Do not remove/install the memory module. The computer or the

module could be damaged.

Do not remove the Battery Pack.

In any of the above cases, the Standby Mode configuration will not be

saved.

If you carry the computer on board an aircraft or into a hospital, be sure

to either switch it off fully or place it into Hibernation Mode to avoid any

radio signal interference.

Do not turn the computer or devices back on immediately. Wait a moment

to let all capacitors fully discharge.

If the computer is not used or accessed in any way, including receipt of

e-mail, for 15 minutes when the AC adaptor is connected, the computer

will automatically enter Standby Mode (TOSHIBA Power Management

Utility default).

To restore operation, press the power button.

If a network application is active when the computer automatically

enters Standby Mode, its status might not be restored when the

computer is next switched on. To prevent the computer from

automatically entering Standby Mode, disable the Standby function in

the TOSHIBA Power Management Utility. Open the TOSHIBA Power

Management Utility and click the Power Save Modes tab. Next select

either an AC Power or Battery Power option and then click Details.

When the Details page comes up, you can disable Standy Mode setting

be moving the slider to Never, however please note that in doing this

you will nullify the computer's Energy Star compliance.

Advertising