Toshiba Qosmio X500 - Manual (Page 102)

User’s Manual 4-28
Operating Basics
■ Use the audio/video control buttons to reproduce music or voice.
■ Open the BD drive or DVD Super Multi drive.
■ Do not shut down/log off or enter Sleep Mode/Hibernation Mode while
writing or rewriting.
■ Make sure writing or rewriting is complete before going into Sleep
Mode/Hibernation Mode. Writing is complete if you can open the BD
drive or DVD Super Multi drive tray.
■ Set the computer on a level surface and avoid places subject to
vibration such as airplanes, trains, or cars. Do not use an unstable
surface such as a stand.
■ Keep mobile phones and other wireless communication devices away
from the computer.
■ Always copy data from the hard disk drive to the CD-R/-RW,DVD-R/
-RW/-RAM, DVD+R/+RW or BD-R/-RE disc. Do not use cut-and-paste.
The original data will be lost if there is a write error.
Disclaimer (DVD Super Multi drive or BD-R/RE drive)
TOSHIBA does not bear responsibility for the following:
■ Damage to any CD-R-RW or DVD-R/-R(DL)/-RW/+R/+R(DL)/+RW/
-RAM or BD-R/RE disc that may be caused by writing or rewriting with
this product.
■ Any change or loss of the recorded contents of CD-R-RW or DVD-R/
-R(DL)/-RW/+R/+R(DL)/+RW/-RAM or BD-R/RE disc that may be
caused by writing or rewriting with this product, or for any business
profit loss or business interruption that may be caused by the change or
loss of the recorded contents.
■ Damage that may be caused by using third party equipment or
software. Given the technological limitations of current optical disc
writing drives, you may experience unexpected writing or rewriting
errors due to disc quality or problems with hardware devices. Also, it is
a good idea to make two or more copies of important data, in case of
undesired change or loss of the recorded contents.
Data Verification
To verify that data has been written or rewritten correctly to a data CD/DVD,
you should follow the steps below before you begin the write/rewrite pro-
cess:
1. Display the setting dialog box by one of the following two steps:
■ Click Recording settings ( ) for writing on the main toolbar in
the Data Disc mode.
■ Select Setting for Each Mode  Data Disc in the Setting menu.
2. Mark the Verify written data check box.
3. Select File Open or Full Compare mode.
4. Click OK.