Leaning & maintenance – Sharp R-21ATP User Manual

Page 32

Advertising
background image

31

Do not allow grease or dirt to build up on the door

seals and adjacent parts as this may prevent the
door from closing correctly and may cause a leak-
age of microwaves. To clean use a mild detergent
solution on a soft damp cloth.

Keep the ceramic floor clean at all times. If you leave

grease or fat in the cavily, it may overheat, smoke or
even catch fire when next using the oven.

Never use spray cleaners, oven keys or abrasive scour-

ers as these damage the surface of the oven.

Do not remove the ceramic floor from the oven.

Do not operate the oven without the air ventilation cover.

Do not use commercial oven cleaners, abrasive or

harsh cleaners or scouring pads on any part of your
microwave oven.

Do not sprinkle water onto the oven directly. It may

cause electric shock, leakage of electricity or damage
of the oven.

Failure to maintain the oven in a clean condition could

lead to deterioration of the surface that could adversely
affect the life of the appliance and possibly result in a
hazardous situation.

LEANING & MAINTENANCE

C

WARNING

Clean the microwave oven cavity, at the end of each day
with a damp soft cloth. For heavier soil, use mild soap
applied with a soft damp cloth wipe clean ensuring all
mild soap is removed. Make sure that mild soap or water
does not penetrate through the small vents in the walls
which may cause damage to the oven. Take care not to
let soapy water drip through the small holes in the oven

walls. Excess water spillage through these holes will
cause damage to the oven interior. It is important that the
door seals and sealing surfaces are kept clean at all times,
wipe regularly with a damp cloth.
The ceramic floor should be kept clean at all times. Minor
spills may be wiped with a damp cloth.

OVEN INTERIOR

Wipe the outside cabinet with a mild detergent solution
on a soft cloth. The control panel must be wiped clean
whilst the door is open, therefore inactivating the oven.

OUTER CABINET

Keep the air intake filter clean. Clean the air intake filter
once every two weeks.
Wash the air intake filter in mild soapy water, rinse and
dry with a soft cloth.
You can remove the air intake filter easily using a coin
(less than 2mm thick.)
Do not operate the oven without the air intake filter in
place.
Removal:
1. Remove one special screw (A) as shown in Fig.1.
2. Remove the upper holder from the air intake filter.
3. Remove the air intake filter from the lower holder.
Reinstall:
1. Insert the air intake filter into the slot of the lower holder.
2. Place the upper holder on the air intake filter.
3. Secure the upper holder and air intake filter to the oven

with one special screw (A) as shown in Fig. 1.

AIR INTAKE FILTER

Fig. 1

Upper holder

Air intake
filter

Lower holder

(A)

Advertising