Neff C47C62N3GB - Manual (Page 12)

12
After each use
Emptying the water tank.
1. Open the appliance door carefully.
Hot steam will escape.
2. Remove and clean the water tank.
3. Thoroughly dry the seal in the tank cover and the tank recess
in the appliance.
Caution!
Do not dry the water tank in the hot cooking compartment. This
will damage the water tank.
Drying the cooking compartment
:
Risk of scalding!
The water in the evaporator dish may still be hot. Allow it to cool
before wiping.
1. Leave the appliance door ajar until the appliance has cooled
down.
2. Once it has cooled down, wipe out the cooking compartment
and the evaporator dish with the enclosed cleaning sponge
and dry well with a soft cloth.
3. Remove food residues from the cooking compartment as
soon as the appliance has cooled. Burnt-on remains will be
much harder to remove later.
4. Wipe kitchen units or handles if condensation has formed on
them.
Electronic clock
In this section, you can read about
■
how to set the timer
■
how to switch your appliance off automatically (cooking time
and end of operation)
■
how to switch your appliance on and off automatically (preset
operation)
■
how to set the time
Clock display
Notes
■
Between the times ƒƒ : ‹‹ and † : †Š the clock display is
dimmed if you do not make any settings in that period or no
clock function is activated.
■
When you set a clock function, the time interval increases
when you set higher values (e.g. cooking time up to ‚ : ‹‹œ to
the minute, using ‚ : ‹‹œ
to the nearest 5 minutes).
■
For the Q minute minder, x cooking time, y end of
operation and preselection mode clock functions, a signal
sounds when the settings have elapsed and the Q or y
symbol flashes. To cancel the audible signal before it ends,
press the KJ clock function button.
■
Briefly press the KJ clock function button to select a clock
function. You then have 3 seconds to set the selected clock
function. After this time, the setting mode is exited
automatically.
Switching the clock display on and off
1. Press and hold the KJ clock function button for 6 seconds.
The clock display switches off. If a clock function is active,
the associated symbol remains lit.
2. Press the KJ clock function button briefly.
The clock display switches on.
Timer
1. Press the KJ clock function button repeatedly until the KJ
and Q symbols light up.
2. Set the duration using the rotary selector (e.g. † : ‹‹ minutes).
The setting is applied automatically. Then the clock is
displayed again and the minute minder starts counting down.
&ORFNIXQFWLRQEXWWRQ 5RWDU\VHOHFWRU
Clock function Use
Q Minute minder You can use the minute minder as an egg timer or a kitchen timer. The appliance does
not switch on or off automatically
x Cooking time The appliances switches off automatically after a cooking time setting has elapsed
(e.g. ‚ : „‹ hours)
y End of operation The appliance switches off automatically at a set time (e.g. ‚ƒ : „‹ o'clock)
Preset operation The appliance switches on and off automatically. Cooking time and end of operation
have been combined.
3 Clock Setting the clock