Neff C47C62N3GB - Manual (Page 13)

13
Cooking time
Automatic switch-off after a cooking time setting has elapsed.
1. Set the operating mode and temperature.
2. Press the KJ clock function button repeatedly until the KJ
and x symbols light up.
3. Set the cooking time with the rotary selector
(e.g. ‚ : „‹ hours).
4. Press the Start button.
When é steam cooking, the cooking time does not start until
the heating up time has elapsed.
Once the cooking time has elapsed, the appliance switches off
automatically.
1. Turn the operating mode selector back to the Û position.
2. Press the KJ clock function button to exit the clock function.
End of operation
Automatic switch-off at a set time. This function is only possible
for operating modes that do not use steam.
1. Set the operating mode and temperature. Press the Start
button.
The appliance heats up.
2. Press the KJ clock function button repeatedly until the KJ
and y symbols light up.
3. Set the end of operation using the rotary selector
(e.g. ‚ƒ : „‹ o'clock).
The setting is applied automatically. The clock is then
displayed again.
The appliance switches off automatically at the time set for the
end of operation.
1. Turn the operating mode selector back to the Û position.
2. Press the KJ clock function button to exit the clock function.
Preset operation
The appliance switches on automatically, then switches off
automatically at the time preselected for the end of operation.
Bear in mind that food that spoils easily must not stay in the
cooking compartment for too long.
Preselection mode is not possible with some of the automatic
programmes.
When
é Steam cooking, the cooking time does not start until
the heating up time has elapsed. The end of operation which
was set is therefore delayed by the length of time required for
heating-up.
1. Set the operating mode and temperature.
2. Press the clock function button repeatedly until the KJ and
x symbols light up.
3. Set the cooking time with the rotary selector
(e.g. ‚ : „‹ hours).
4. Press the clock function button repeatedly until the KJ
and y symbols light up.
5. Set the end of operation using the rotary selector
(e.g. ‚ƒ : „‹ ).
6. Press the Start button.
The appliance waits until the appropriate time to switch on (in
the example at ‚‚ : ‹‹ ).
The appliance switches off automatically at the time set for the
end of operation ( ‚ƒ : „‹ ). A signal sounds and the y symbol
flashes.
1. Turn the operating mode selector back to the Û position.
2. Press the clock function button to end the preselection mode.
Setting the clock
You can only change the clock when no other clock function is
active.
1. Press the KJ clock function button repeatedly until
the KJ and 3 symbols light up.
2. Set the clock using the rotary selector.
The setting is applied automatically.
Checking, correcting or deleting settings
1. To check your settings, press the KJ clock function button
repeatedly until the corresponding symbol lights up.
2. If necessary, you can correct your setting using the rotary
selector.
3. If you wish to cancel your setting, turn the rotary selector anti-
clockwise to the original value.