Neff C47C62N3GB - Manual (Page 23)

23
Starting the cleaning aid
1. Press the operating mode selector to make it pop out.
The appliance switches on.
2. Turn the operating mode selector to > EasyClean®.
3. Fill the water tank with water up to the "max" mark and slide it
in.
4. Press the Start button.
The cleaning aid starts running. The light in the cooking
compartment remains switched off. “’† appears in the
temperature display.
Emptying the evaporator dish and wiping out the appliance
A signal sounds after approx. 30 minutes. "Wipe out appliance"
appears in the text display.
1. Open the appliance door.
2. Take the rails out of the cooking compartment and clean
them (see section: Cleaning the rails).
3. Wipe out all loosened food residues from the cooking
compartment and the evaporator dish using a soft washing-
up brush and the cleaning sponge.
4. If required, fill the water tank with water and reinsert it.
5. Close the appliance door.
1st rinse
Press the Start button.
The appliance starts rinsing. "1st rinse" appears in the display.
Empty evaporator dish
After 20 seconds, "Empty evaporator dish" appears in the text
display.
1. Open the appliance door.
2. Thoroughly rinse out the cleaning sponge.
3. Remove the remaining water from the evaporator dish using
the cleaning sponge.
4. Close the appliance door.
2nd rinse
Press the Start button.
The appliance starts rinsing. "2nd rinse" appears in the display.
Removing the remaining water
After 20 seconds, "End" and "Empty evaporator dish" appear in
the text display.
1. Open the appliance door.
2. Remove the remaining water from the evaporator dish using
the cleaning sponge.
3. Wipe out the cooking compartment using the cleaning
sponge and then dry with a soft cloth.
4. Turn the operating mode selector back to the Û position.
5. To turn off the appliance, press in the operating mode
selector so that it clicks into place.
The cleaning aid is complete.
Cancelling the cleaning aid
Note: After cancelling the cleaning aid, the appliance must be
rinsed twice. The appliance is locked against other applications
until the second rinsing operation is complete.
1. Press and hold the Stop button to cancel the Cleaning aid.
To ensure that no washing-up liquid remains in the appliance,
it must be rinsed twice after a cancellation.
2. Press the Start button.
"Wipe out appliance" appears in the display.
3. If required, fill the water tank with water, reinsert it and press
the Start button.
Now proceed as described in the section “Emptying the
evaporator dish and wiping out the appliance”.
Descaling
The appliance must be descaled at regular intervals in order for
it to continue operating correctly. "Descale the appliance"
reminds you of this.
You can only dispense with descaling completely if you
exclusively use softened water.
The descaling consists of:
■
Descale (approx. 30 minutes), then empty the evaporator
dish and refill the water tank
■
1st rinse (20 seconds), then empty the evaporator dish
■
2nd rinse (20 seconds), then remove the remaining water
All three steps must be completed in full. The appliance is
ready for operation again only after the 2nd rinse.
Descaler
Only use the liquid descaler recommended by the after-sales
service for descaling (product no. 311 138, also available
online from the eShop). Other descalers may damage the
appliance.
1. Prepare a descaling solution by mixing 300 ml water and
60 ml liquid descaler.
2. Empty the water tank and fill with descaling solution.
Caution!
Risk of surface damage: If descaler comes into contact with the
front of the appliance or any other sensitive surfaces, wash it off
immediately with water.
Starting descaling
The cooking compartment must have cooled down completely.
1. Press the operating mode selector to make it pop out.
The appliance switches on.
2. Turn the operating mode selector to Í Descale.
3. Slide in the water tank containing the descaling solution and
close the appliance door.
4. Press the Start button.
The descaling process starts. The light in the cooking
compartment remains switched off.
Emptying the evaporator dish and refilling the water tank
An audible signal sounds after approx. 30 minutes. "Empty
evaporator dish and refill water tank" appears in the text
display.
1. Open the appliance door.
2. Remove the descaling solution from the evaporator dish
using the cleaning sponge provided.
3. Rinse the water tank thoroughly, fill with water and reinsert.
"Appliance ready to rinse" and "1st rinse" appear in the text
display.
4. Close the appliance door.
1st rinse
Press the Start button.
The appliance starts rinsing. "1st rinse" appears in the display.
Empty evaporator dish
After 20 seconds, "Empty evaporator dish" appears in the text
display.
1. Open the appliance door.
2. Thoroughly rinse out the cleaning sponge.