Neff B45C52N3GB - Manual (Page 12)

12
After each use with steam assistance
1. Switch off the appliance.
The remaining water will be pumped out of the evaporator
system and back into the water tank. The Ì symbol lights up
during this time.
2. Only empty the water tank when the Ì symbol is no longer
lit.
3. Empty and clean the water tank and allow it to dry with the
door open.
4. Dry the cold cooking compartment with a soft cloth.
5. Remove any dirt from the cooking compartment.
Note: Remove limescale with a cloth soaked in vinegar, then
wipe with clean water and rub dry with a soft cloth.
Automatic safety cut-out
The automatic safety cut-out is activated if your appliance is
switched on and you have not made any settings for a long
time.
The length of time after which your appliance switches itself off
depends on the settings that you make.
‹‹‹ flashes in the temperature display. Appliance operation is
interrupted.
Turn the operating mode selector to the
Û position to
deactivate it.
Changing the Basic settings
Your appliance has various Basic settings, which are preset at
the factory. You can, however, change these Basic settings as
required.
1. Switch on the appliance.
2. Press and hold the ± info button for 3 seconds to go to
the Basic settings menu.
™‚‹ appears in the display (appliance unlocked).
3. Press the ± info button repeatedly until the setting symbol for
the current basic setting of a submenu appears in the
temperature display (e.g. ™„ƒ Audible signal 2 minutes).
4. Use the temperature selector to set the required basic setting
within a submenu (e.g. ™„„ Audible signal 10 minutes).
5. Press and hold the ± info button for 3 seconds.
Your basic setting is saved.
Note: If you do not make any changes within 15 seconds, the
appliance automatically exits the Basic settings menu.
You can change the following Basic settings:
Basic settings menu
Submenu
Basic setting Setting
symbol
Childproof lock Appliance unlocked ™‚‹
Appliance locked ™‚‚
Appliance permanently
locked
™ƒ‚
Audible signal Audible signal off ™„‹
Audible signal
30 seconds
™„‚
Audible signal 2 minutes ™„ƒ
Audible signal
10 minutes
™„„
Water hardness softened ™…‹
soft ™…‚
medium ™…ƒ
hard ™…„
Altitude calibration below 0 m ™†‹
0 - 300 m ™†‚
300 - 600 m ™†ƒ
600 - 900 m ™†„
900 - 1200 m ™†…
1200 - 1500 m ™††
1500 - 1800 m ™†‡
1800 - 2100 m ™†ˆ
2100 - 2400 m ™†‰
above 2400 m ™†Š
Factory settings Do not restore ™‡‹
Restore ™‡‚
Basic settings menu
Submenu
Basic setting Setting
symbol