Caution changing the pattern length – Brother NX-450 User Manual
Page 125
UTILITY STITCHES
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
124
d
Press
or
(Stitch width keys) until the
desired density is selected.
Select
for sparse stitching or select
for
compact stitching.
e
Press
(OK key) or
(Cancel/clear key).
X
The initial stitch screen appears again, and
the stitching density is changed.
CAUTION
Changing the pattern length
The length of one part of a satin stitch can be set to
one of five sizes.
a
Select a satin stitch (No. 32–47 of
,
selected with
).
b
Press
(Settings key) in the operation
panel.
X
The settings screen appears.
c
Press
or
(Stitch length keys) until
is displayed.
X
The screen for changing the length of a satin
stitch appears.
d
Press
or
(Stitch width keys) until the
desired ratio is selected.
The length can be set within the range of
and .
• Press
to reduce the length. If the key is
pressed while the smallest setting (×1) is
displayed, a beep sounds.
• Press
to increase the length. If the key is
pressed while the largest setting (×5) is
displayed, a beep sounds.
X
The satin stitch length is changed.
e
Press
(OK key) or
(Cancel/clear
key).
X
The initial stitch screen appears again.
● If the stitching density is too compacted,
depending on the needle, the stitches may
be bunched together, causing the needle
to break.