Barco RLM G5I PERFORMER R9010320 - Manual (Page 35)

4. Getting Started
No. Key name Description
1 Function keys user programmable keys with functions for direct access.
2 MENU Menu key, to enter or exit the Tool bar menu.
3 Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
4 LOGO key allows to recall the stored Logo (not in PiP mode)
5 PAUSE to stop projection for a short time, press ’PAUSE’. The image disappears but full power is
retained for immediate restarting.
6 STBY standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to
go to standby, press the standby key for 2 seconds.
7 TEXT to des-activate or activate the on screen dialog boxes and menus.
8 AUTOIMAGE Auto image, to center the image on the active DMD surface.
9 Digit buttons direct input selection.
9b SOURCE button this button allows to switch through the active (scanned) inputs
10 Lens control use these buttons to obtain the desired ZOOM, SHIFT, FOCUS.
11 VOL Used as lens shift left - right.
12 Picture controls use these buttons to obtain the desired picture analog level.
13 DIGI ZOOM allows a digital Zoom of a part of the image
14 FREEZE press to freeze the projected image.
15 PIP allows to activate the PICTURE IN PICTURE mode
16 ENTER to confirm an adjustment or selection in the MENU.
On the local keypad and the RCU, the ENTER button additionally accesses the PIP
window re-size function
17 Cursor keys Cursor Keys on RCU or on the local keypad : to make menu selections or to access the
menu bar.
18 BACK to leave the selected menu or item (go upwards to previous menu).
19 EFFECTS not yet implemented
20 PIP ADJUST allows to select a PiP window and change its configuration on screen
21 RC operating indication lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
22 IR receiver IR receiver
Green Red
Led 1 IR acknowledgement Standby
Led 2 Hardware error
Led 3 Cool down sequence: flickers 60 seconds
after switching to standby rescue program (software error)
R5976815 RLM G5I PERFORMER 02/06/2006 33