Barco RLM G5I PERFORMER R9010320 - Manual (Page 84)

8. Image Menu
Input balance is also available for a component video source under following conditions:
• A component video signal is present on the BNC’s.
• ”Data on BNC’s” is selected in the Source selection menu.
• Pr/Y/Pb is selected in the Advanced menu of the corresponding image file.
The procedure is the same as for a data source except:
• The white balance happens only on Green.
Adjust until bright spots appear in the image.
Image 8-43
• The black balance happens on the three colors.
The PR and PB connector have to be removed from the input.
Adjust until noise appears in the image.
Image 8-44
8.10 AGC on Video
AGC
Automatic Gain Control: allows an automatic amplitude (gain) control of the incoming video signal
AGC is only for Video signals.
Enabling/disabling the AGC
1. Press MENU to activate the menu bar.
2. Press → to select the Image item.
3. Press ↓ to pull down the Image menu.
4. Use ↑ or ↓ to select AGC on Video.
82 R5976815 RLM G5I PERFORMER 02/06/2006