Bushnell ImageView 11-8200 - Manual (Page 4)

6 7
Congratulations on your purchase of a Bushnell ImageView binocular. Before using
the product, please read these instructions and take time to familiarize yourelf with the
different parts and features of the product.
BINOCULAR INSTRUCTIONS
TURNING THE CAMERA ON AND OFF
Insert 2 AAA alkaline batteries as indicated on
the inside of the battery compartment, located
on the bottom of the camera unit. Turn the
camera on by pressing and holding the MODE
button until the display comes on and the
camera beeps. To turn the unit off, press and
hold the MODE button until the display goes
out. The camera will turn itself off automatically
to save batteries if none of the buttons have been
pressed for two minutes.
TAKING A PICTURE
With the camera turned on, press the SNAP
button to take a new photo. For best results, hold
the ImageView steady using both hands, and
lightly press down the SNAP button using the flat end of your finger rather than “punching” it with
a fingertip. Be sure you are at least 30 feet away from your subject as the camera focus is preset for
optimum results with distant objects (sports, wildlife, etc.).
QUICK GUIDE: BUSHNELL IMAGEVIEW 11-8200
TAKE A PHOTO (TIPS FOR BETTER QUALITY PHOTOS)
Holding the ImageView as steadily as possible with both hands wrapped around the binocular,
lightly press down the SNAP button using the flat end of a finger. Leaning against a wall, tree, etc. to
brace yourself can also help insure the camera does not move as you take the photo. Make sure you
are at least 30 feet or more away from your photo subject. Unlike the binocular optics (which will
focus down to about 15 ft.), the camera focus is preset and is designed only for distant subjects- your
photos may look out of focus if you were too close.
USING THE IMAGEVIEW WITH YOUR COMPUTER
BEFORE CONNECTING THE IMAGEVIEW TO A COMPUTER, first install the driver from
the CD-ROM as directed in “Software Installation”. After the driver has been installed, you may
install Roxio® PhotoSuite 5 as well, following the on-screen instructions (if you do not already
have photo software you prefer to use). Connect the supplied USB cable between the ImageView
and your computer, using a USB port on the computer itself (avoid USB “hubs”). Please read
“Downloading Photos to Your Computer” for detailed instructions on transferring photos to a PC
using PhotoSuite.