Brother HL-2400Ce - Manual (Page 188)

CHAPTER 5 MAINTENANCE
5-41
Modular I/O Card
Before installing an NC-2010h/2100h Network card, please note the
following information.
Before NC-2010h/2100h Installation
(USA)
When you install the NC-2010h/2100h Ethernet interface card, this printer
complies with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules.
Please refer to the NC-2010h/2100h User’s Guide for the FCC notice.
(CANADA)
When you install the NC-2010h/2100h Ethernet interface card, this printer
complies with the limits for a Class A digital apparatus, pursuant to
Canadian Interference-Causing Equipment Regulations.
(Europe)
When you install the NC-2010h/2100h Ethernet interface card, this printer
complies with EN 55022 Class A.
Warning
In a domestic environment, the printer used with an NC-2010h/2100h
Network card may cause radio interference, in which case the user
may be required to take adequate measures to prevent any such
interference.
This printer has a modular input/output (MIO) interface slot on the rear
panel. This slot allows you to install a commercial MIO-compatible
sharing/network card.
For more information about MIO cards, consult the dealer where you
purchased this printer.
To install an MIO card, follow these steps:
1. Turn off the printer and unplug the power cord from the wall socket.
✒ Note
•
Be sure to turn off the power to the printer before installing or
removing the MIO card.
•
Be sure to remove the interface cable connector when installing the
MIO card.