Brother HL-2400Ce - Manual (Page 190)

CHAPTER 5 MAINTENANCE
5-43
The following capacity of DIMM can be installed:
• 16 Mbyte TECHWORKS PM-HP 16M-BR
• 32 Mbyte TECHWORKS PM-HP 32M-BR
• 64 Mbyte TECHWORKS PM-HP 64M-BR
• 128 Mbyte TECHWORKS PM-HP 128M-BR
In general, the DIMM must have the following specifications:
Type: 100 pin and 32 bit output
CAS Latency: 2 or 3
Clock Frequency: 66Mhz or more
Capacity: 16,32, 64 or 128 Mbyte
Height: 46mm (1.8 inches) or less
Parity: NONE
Dram Type: 64 M bit SDRAM 4 Bank
SDRAM can be used.
✒ Notes
•
There might be some DIMMs which will not work with this printer.
• For more information, consult the dealer where you purchased the
printer.
•
For the latest information: http://www.brother.com
To install DIMMs, follow these steps:
1. Turn off the printer and unplug the power cord from the AC
outlet.
✒ Note
Be sure to turn off the power to the printer before installing or removing
the DIMMs.