Brother HL-2400Ce - Manual (Page 85)

CHAPTER 4 CONTROL PANEL
4–21
Display Message Parameters Settings
DTR(ER) =ON
(Effective when
Xon/Xoff=ON)
Data terminal ready
(ER) ON: Makes DTR (ER) low when
the buffer is full.
OFF: Does not make DTR (ER)
low when the buffer is full.
DTR(ER) goes low only
when the printer is off-line.
Robust Xon =OFF
(Effective when
Xon/Xoff=ON)
Robust Xon ON: Sends Xon while waiting.
OFF: Sends Xon once, when the
printer status changes from
off-line to on-line.
■ Extended I/O Interface
If you have installed a commercial modular input/output (MIO) card in
the printer, you can select the extended I/O interface in this mode. If the
installed MIO card requires any optional interface settings, they appear
under this menu. Set them, referring to the manual of the MIO card.
✒ Note
This setting appears only when an MIO card has been installed. For
installation of the MIO card, see the Network manual.
The network card may be pre-installed on some HL-2400Ce series
models.