Brother HL-2400Ce - Manual (Page 84)

USER’S GUIDE
4–20
■ Parallel Interface
When you use the parallel interface, you must set the communications
mode in the following sub-setting menu.
Display Message High Speed and Bi-directional
Parallel Communications
HIGH SPEED=ON Turn on or off the high speed
parallel communications.
BI-DIR=ON Turn on or off the bi-directional
parallel communications.
The above high-speed and bi-directional settings are used for the
bi-directional parallel interface of this printer. The bi-directional parallel
interface is compatible with the IEEE 1284 standard. Although it uses the
same cable, hardware and software as the bi-directional parallel interface,
to use its enhanced capabilities—such as bi-directional communication
between the computer and printer and faster transmission of data—you
must install the Brother driver supplied on the CD-ROM included with
the printer or a third party printer driver or software that supports these
features. Check with your software vendor to see if your software
supports bi-directional parallel features.
■ Serial Interface
If you intend to use the serial interface, be sure to select the same
communications parameters on both the printer and computer. You must
also set them for the automatic interface selection.
Display Message Parameters Settings
BaudRate= 9600 Baud rate
(Data transfer speed) 150, 300, 600, 1200, 2400, 4800,
9600, 19200, 38400, 57600, 115200
baud
CodeType=8 bits Code type
(Data length) 7 bits or 8 bits
Parity =NONE Parity
(Data error check) None, even, or odd
Stop Bit=1 bits Stop bits
(Data separator) 1 or 2
Xon/Xoff=ON Xon/Xoff
(Handshake protocol) ON: DTR & Xon/Xoff handshake
OFF: DTR handshake only