Bobbin winding / bobbin thread setting, Winding the bobbin and setting the bobbin thread, Caution – Brother PC-2800 User Manual
Page 13
10
1
2
3
BOBBIN WINDING / BOBBIN THREAD SETTING
Winding the bobbin and setting the bobbin thread
1. Connect the machine to the power supply and turn on the main
power.
2. Place the spool of thread on the spool pin. The thread end
should come from the bottom front of the spool. The spool cap
closest to the thread spool size should be used to hold the
spool securely on the spool pin.
1
Spool cap
2
Spool
3
Spool pin
*
The spool cap should be pushed on as far as it will go.
CAUTION
• If the thread spool and/or spool cap are set
incorrectly, the thread may tangle on the spool pin
and cause the needle to break.
• Use the spool cap (large or small) that is closest
in size to the thread spool. If a spool cap smaller
than the thread spool is used, the thread may
become caught in the slit on the edge the spool
and cause the needle to break.
Note
If using a fine thread such as cross wound thread, slightly sepa-
rate the spool cap (small) from the spool of thread before using it.
1
Cross wound thread
2
Spool cap (small)
3
Gap
CAUTION
Use only bobbins recommended by the manufacturer of this machine (see page 5). Using
other bobbins may result in damage or injury.
1
2
3
1
5
2
4,9
7,8
3
6
6