Caution – Brother PC-2800 User Manual
Page 14
11
4. Align the groove in the bobbin with the spring on the shaft and
place the bobbin on the bobbin winder shaft. Then, push the
bobbin winder shaft to the right.
1
Spring on the shaft
2
Groove of the bobbin
5. Wind the thread clockwise around the bobbin four or five times,
pass the end of the thread through the slit in the bobbin winder
seat, and then pull the thread in the direction shown in the
illustration. Use the cutter to cut the thread.
1
Bobbin winder seat
CAUTION
Be sure to follow the process described. If the
thread is not cut with the cutter, and the bobbin is
wound, when the thread runs low it may tangle
around the bobbin and cause the needle to break.
6. Slide the sewing speed controller to its maximum (as far to the
right as possible).
7. Press the “START/STOP” button. The bobbin will stop winding
when it is full.
8. After the bobbin has stopped moving, press the “START/STOP”
button to stop the machine.
9. Cut the thread, slide the bobbin winder shaft to the left and
remove the bobbin.
Note
Immediately after winding the bobbin, it is normal to hear the sound
of the clutch engaging when beginning to sew or manually turning
the balance wheel.
3. Pass the thread through the thread guide as shown by the
arrows.
2
1
2
1
1
1
2
3