Baumfolder Baumcut Programmable 26.4 - Manual (Page 26)

K3 - 2
1 2 3 4 5 6 7 8 9
C 0
x D i
PROGRAMMABLE
2
3.0 Start Up
Switching Machine ON
Attention!
Prior to any commissioning and any change of shifts
the operating staff has to check if the safety related
machine elements are in proper service condition and
complete.
1. Turn main switch (2) from "0" to "I"
< Control voltage is switched on.
After several seconds display shows Program data display >
Turning Machine OFF
1. Wait until automatic operations have ended.
2. Turn main switch from " I " to "0" position
to prevent a start-up of the machine:
Place padlock into main switch, lock it and remove the key.