Baumfolder Baumcut Programmable 26.4 - Manual (Page 93)

K6 - 5
The BAUM sinus cutting stick is made of high resistance plastic material.
Due to the unusual wavy design a tight fitting in the table grove is assured
without the need for glue or screw.
Each cutting stick is useable 4 times as they are turned around.
Removing of cutting stick
Tool needed: normal screw driver
1. Lift cutting stick slightly on the left side cutting stick stop
2. Prey out cutting stick carefully from left toward the right.
Clean cutting stick table grove!
Inserting of cutting stick
1. Rest cutting stick end against the right stop and work into the grove
2. Follow the wavy form of the cutting stick when pressing into the table
grove. Press down hard to assure total seating of stick.
6.0 Knife Change
Changing of cutting stick
normal turn over replace