Bogen PM-3180 - Manual (Page 21)

Wiring Information
Outputs For PM-3000 Preamplifier
Each preamplifier channel has its own balanced output terminals and unbal-
anced RCA output jacks on the rear panel to handle different amplifier and
signal processing inputs.
15
1. This figure shows wiring
from the PM-3000
Balanced Output to a
standard XLR-type of
balanced amplifier input.
2. This figure shows wiring
from PM-3000 Balanced
Output to an unbalanced
input. Note: this wiring
style into an unbalanced
input will result in 6dB
less maximum input sig-
nal. The unbalanced
connection shown in 3. is
preferred.
3. Wiring for PM-3000 into
unbalanced inputs.
Provides maximum sig-
nal level drive into unbal-
anced inputs.
1
2
3
Note 1. In some instances, connecting the cable shield
to both the PM-3000 ground and the amplifier’s input
ground may cause ground loops. In that case, remove
the shield connections to the PM-3000.
Note 1