Bogen PM-3180 - Manual (Page 33)

Programming
4. The display shows A ALC ON indi-
cating that MIC A ALC status is
ON.
5. Press the NEXT or BACK but-
tons to select ON or OFF.
6. Press ENT to store the selection.
7. The display shows A PPS OFF indi-
cating that the MIC A phantom
power is OFF. If Mic B is set as
a TEL input (see below),
PPS will
not be shown since it does not
apply to tel inputs.
8. Press the NEXT or BACK but-
tons to select
ON or OFF .
9. Press ENT to store the selec-
tion. At this point, the display again shows the precedence display.
Press EXIT to return to the function menu or press the MIC B button to
configure MIC B.
Note: During mic configuration, you can switch between MIC A or MIC
B. For example, when the display shows PPS (phantom power) for MIC
A, you can press MIC B and set the phantom power feature for MIC B.
The same holds true for the PREC and ALC features.
To Set MIC B for TEL Operation
Located between the ALC and PHAN features is the MIC B TEL setup fea-
ture:
1. The display shows B IN-MIC which indicates that MIC B is set for use with
microphones.
2. Press the NEXT or BACK buttons
to select MIC or TEL.
3. Press ENT to store the selec-
tion. If set for MIC, the next dis-
play shows
PPS . If set to TEL , the
next display shows PREC .
4. Press EXIT to get to the main menu or continue with other functions.
B IN-MIC
A ALC ON
A PPS OFF
27