Bogen PM-3180 - Manual (Page 34)

Programming
Presets
This feature lets the installer adjust the power-up volume, bass and treble of
each amp/channel-input combination. It also sets the relative volume levels
between different inputs on a particular amplifier channel. The same inputs
can have different volume and EQ settings on different amps.
Note: The system should be completely wired before making
any of these adjustments, since the installer will normally want
to listen to the output in order to make the adjustment.
Additionally, the input trim levels should be set correctly; see
page 10 for information on adjusting trim levels.
1. Enter programming mode and press the NEXT or BACK buttons until
PRESETS appears on the display.
2. Select the desired control (VOL, BASS or TREB) by pressing the corre-
sponding button.
3. Select the amplifier and input you wish to adjust by pressing the appro-
priate selector buttons.
4. Press ENT to enter the function.
The display shows the current
amp-input combination and pre-
set level for the selected control.
In the illustration at right, VOL is
the selected control. The display
A1/AUXA10 . indicates that the preset
volume level for the Amp 1-Aux
A combination is 10 (on a scale
of 00 - 25; 10 is the factory default level).
4. Press the arrow buttons to increase/decrease the
volume. The preset number will increase or
decrease, and the pointer will move left or right in
response to the changes made.
A1/AUXA 10
28