Liebherr ECBN 5066 PremiumPlus BioFresh NoFrost - Manual (Page 15)

Malfunctions
You may be able to rectify the following faults by checking
the possible causes yourself:
Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the fuse intact?
Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects
to vibrate? Please note that noises caused by the refrigerant
circuit cannot be avoided.
The temperature is not cold enough:
– Is the temperature setting correct (see "Setting the tempera-
ture")?
– Have excessive amounts of fresh food been placed in the ap-
pliance?
– Does the separately installed thermometer show the correct
reading?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes
apply and you cannot rectify
the fault yourself, contact the
nearest customer service de-
partment stating the type des-
ignation 1 , service number 2
and appliance number 3 as
indicated on the type plate.
The position of the type plate
is shown in the section entitled
Description of the appliance.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or switch off or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.
GB
Removing the freezer drawer containers
• Open the refrigerator door.
• Pull out the freezer drawer.
• Pull the container upwards by the right and left corners (1).
• Push the container backwards (2).
• Tilt the container at an angle and remove.
• Install the container in the reverse order.
Side view of the freezer
drawer pulled out
29