Liebherr ECBN 5066 PremiumPlus BioFresh NoFrost - Manual (Page 5)

GB
Switching the appliance on and off
You are advised to clean the appliance before switching it on for
the first time (see "Cleaning").
Do not load with frozen food until the temperature shows at least
-18°C. The refrigerator and freezer compartments can be oper-
ated separately.
Switching off: keep the On/Off icons pressed for approx.
3 seconds.
Temperature display
In normal operation, the following settings
will be displayed:
- the average refrigerator temperature and
- the warmest frozen food temperature.
When starting up for the first time or when the
appliance is warm, dashes will appear until
the temperature reaches a level that can be
displayed (below 0°C in the freezer).
The display will flash:
- if you change the temperature or
- if the temperature rises by several degrees, indicating cold
loss, e.g. if you place fresh, "warm" food in the freezer or if you
remove or re-pack frozen food, the temperature may rise for a
short time due to warm air flowing into the freez er.
If F1 to F5 appears in the display, the appliance has a fault.
Consult the customer serv ice department indicating the fault
number displayed.
Switching on: touch the On/Off icons (on left
for refrigerator, on right for freezer) so that the
temperature displays light up or flash.
Setting the temperature
The appliance is pre-set for normal operation. We recommend
temperatures of +5°C in the refrigerator and -18°C in the freezer.
To reduce the temperature: touch the
Down icon; on left for refrigerator and on
right for freezer.
To increase the temperature: touch the
Up icon.
- While you are entering the temperature, the set temperature
will flash on the display.
- When you touch the temperature setting icons for the first time,
the most recent setting ("reference setting") is displayed.
- You can change the settings in increments of 1°C by briefly
touching the icons again. If the icons are held, the temperature
setting will change faster.
- Approximately 5 seconds after the last touch, the display will
automatically show the actual freezing or cooling temperature
("actual setting").
- You can change the temperatures
in the refrigerator: between 9°C and 3°C and
in the freezer: between -14°C and -28°C.
Installing the water filter
1. Remove the cover of the
filter socket.
2. Insert the filter and turn
it 90° clockwise.
Removing the water filter
3. Turn the filter 90° anti-
clockwise and remove.
Partition for bottom freezer drawer
If required, the partition supplied in the acces-
sories set can be inserted in the bottom
drawer on the left or right.
19